tuftears: Lynx in Chef's Hat (Cooking)
[personal profile] tuftears
This recipe is based on these Chinese curry beef pastries. I had half a jar of beef curry that I'd been meaning to finish up, but no rice to go with it, so I thought I'd try making some pastry turnovers with it as a filling. However, I only had half a jar, so I figured that I should reduce the size of the recipe...

Sadly, there wasn't actually enough pastry dough, based on my reduction (a bit less than a third of the original recipe) to accommodate the beef curry, so I simply heated up the rest of the beef curry in the microwave for dinner.

This is what happens when you overfill a pastry. Probably I should have used some water to seal the edges. Oops. My bad.



You can see the one at the top is closest to fully sealed. That's the one I saved for later, by wrapping it in aluminum foil so I can bake it back again another time. I ate the other two since they are more obviously mistakes. The bottom one is made with the remainder of the dough, and thus a bit misshapen.

I should comment at this point that I really like the empanada/wonton makers I got: they're circular press-things where you can use the bottom side to make circle cut-outs in the rolled-flat dough, then put the dough circle in the top side, add filling, and fold them over to seal them. Much easier than trying to pick up half a section of dough and fold it over.



This is what the bigger one looks like when cut. It's rather more like a buttery pastry shell taco, with a beef curry filling. Yum!

Overall, it seems like a good recipe but I should make more dough relative to the filling.
This account has disabled anonymous posting.
If you don't have an account you can create one now.
HTML doesn't work in the subject.
More info about formatting

Profile

tuftears: Lynx Wynx (Default)
Conrad "Lynx" Wong

January 2026

S M T W T F S
     123
45678910
11121314151617
18192021222324
25262728293031

Most Popular Tags

Style Credit

Expand Cut Tags

No cut tags
Page generated Jan. 24th, 2026 01:07 am
Powered by Dreamwidth Studios